top of page

Stuck at 64% in flower? How long it stays high matters more than the number.

What humidity should I run, and what if I can't hit it?

GROWER ANSWER

Run a range for the stage, not one number: roughly 55 to 70 percent in veg, 45 to 60 percent in early flower, and closer to 40 to 50 once the flowers get dense late in flower. If you can't hit it, how long the humidity stays high, and whether water ever sits on the flowers, matters more than the number on the screen.


Stable and a little off beats perfect and swinging.


▶ Hear it on MyRemy Live: VPD, Leaf Temperature & a Stable Grow Room (18 min) and Humidity Swings, Dehumidifier Mistakes & Meter Accuracy (20 min)


The ranges, by stage

Stage

  • Fresh cuttings under a dome, before roots: Humidity, roughly: 80 to 95% for the first days, then step it down as roots show; VPD, roughly: 0.3 to 0.6

  • Seedlings and rooted clones: Humidity, roughly: 65 to 75%; VPD, roughly: 0.6 to 0.9

  • Veg: Humidity, roughly: 55 to 70%; VPD, roughly: 0.8 to 1.2

  • Early flower: Humidity, roughly: 45 to 60%; VPD, roughly: 1.0 to 1.3

  • Mid to late flower, dense flowers: Humidity, roughly: 40 to 50%; VPD, roughly: 1.2 to 1.5


These are working lanes, not laser targets. There is no single correct value, because the target moves with the stage. A VPD reading of 1.3 that looks like a fail on a veg chart can sit right in the pocket for flower.


VPD is the drying power of the air, how hard it pulls water out of the plant. It is set by temperature and humidity together, not humidity alone. And the leaves usually run a few degrees cooler than the air, so the VPD at the leaf is often lower than the meter shows.


"I can't get it below 64% in flower. Am I at risk?"

Maybe, and the answer is in the pattern, not the one reading. Look at three things: how high it peaks, how long it stays there, and the average across a full day and night.


Usually fine: humidity jumps after lights out, then slowly settles, and everything is dry to the touch. No droplets, no damp smell. When the lights go off the tent cools, cooler air holds less moisture, and the same water in the air reads as a higher percentage. The water did not appear. The temperature changed.


Worth fixing: it climbs into the high 60s or 70s and stays there for hours, especially in mid to late flower, or you see condensation on the walls or leaves. The danger is moisture sitting on plant surfaces, dense flowers and still air. That is where gray mold (botrytis) gets invited in.


What to do when you can't hit your number

  1. Prove the reading first. A lot of humidity emergencies are a cheap meter in a bad spot. Check a hygrometer with a salt test: damp salt in a bottle cap, sealed in a container with the meter for 6 to 8 hours. It should read about 75 percent. Then put the sensor at canopy height, shaded, out of the fan blast, and away from wet pots, walls and the dehumidifier exhaust.

  2. Read the trend, not one scary number. A spike to 68 percent for 20 minutes is a different thing from 68 percent all night.

  3. Keep air moving through the canopy. Not a blast on the flowers, just no dead, still pockets, so a high reading never turns into wet flowers.

  4. Find the free moisture before you buy anything. Empty runoff trays, do not let pots sit in water, check whether the soil is staying soaked too long, and water earlier in the day instead of right before lights out.

  5. Move one lever, gently. Temperature often moves VPD more cleanly than dumping moisture in or out. Make one change, then watch a full day and night before the next one.

  6. If you run a dehumidifier, let it blunt the peak, not erase the curve. Give it a wide band, for example on around 58 and off around 52, instead of fighting to hold exactly 50 all day.


What not to do

Do not go to war on the room at midnight. Cranking the dehumidifier, dropping the AC and adding a humidifier all at once feels like control. But a humidifier and a dehumidifier running against each other just undo each other's work, and the room never settles. It might average out to your number, but the plant does not live in the average. She feels the swings at the leaf.


Do not blast the tent bone dry. Overcorrecting a night spike builds a sawtooth: too humid at night, too dry by day, and the plant gets dragged around by every retune.


Do not fix a happy plant because a chart is yellow. Leaves reaching for the light, good color, steady new growth and pots drying on a normal rhythm are your confirmation the environment is working.


When it is something else


On our shelf in Worcester: Fans, controllers and dehumidifiers are in Climate, air & controls. If mold or pests have already moved in, our Pest plan shelf guide has what we reach for first. Call (508) 459-9609 or get directions.


Is the whole basement damp, not just the tent? Then the dehumidifier belongs in the room the tent breathes from, not inside the tent. When one is worth buying, and what size: Basement and tent humidity: when a dehumidifier is worth it.


Keep going

Watch the episodes: VPD, Leaf Temperature and a Stable Grow Room and Humidity Swings, Dehumidifier Mistakes and Meter Accuracy on MyRemy Live.


The chart works for you. You don't work for the chart. The rest of the system for a stable room is written down in the free Stability Playbook. Get the free Stability Playbook


More answers: all grow guides. Every shelf guide and maker feed chart: Grower Resources.

bottom of page